印度Indian Oil公司“反應器采購”招標

招標單位：Indian Oil Corporation Limited（IOCL）
招標類型：Global Open E-Tender
招標編號：RC/A889-101-RA-MR-6200/1001

項目名稱：BS-VI Project反應器機械設計、檢測、采購
招標內容：
Complete mechanical design including stress analysis by FEA (Finite Element Analysis), detailed engineering, procurement of materials including internals, fabrication at shop, ASME U2 Code Stamping including approval of documents by ASME Authorized Inspector (AI), inspection, testing, post weld heat treatment, hydro-test, primer & finish painting, supply & delivery including installation of thermo-well assembly & thermocouples.

技術規格：

標書費：免費
投標保證金：USD 7800
標書發售周期：2016.7.18-2016.8.17
投標截止時間：2016.8.17 12:00 p.m.
開標時間：2016.8.18 14:00 p.m.

技術要求：
1. Definition of Bidder: Responsible for quoting the complete reactor and owning single point overall responsibility for execution & completion of total job.
2. During the last ten (10) years:
a) Bidder must have designed, shop fabricated, assembled, hydro-tested in single piece at shop and supplied at least one reactor as per ASME Sec. VIII Div. 2 of not less than 1.0 meter diameter and 40 MT fabricated weight with material of construction as 2 ? Cr – 1 Mo – ? V + SS 347 Clad / Weld Overlay of thickness not less than 32 mm of equipment base metal thickness. The above criteria of diameter, thickness, fabricated weight and material shall be complied with by Bidder in same equipment only.
b) Bidder’s fabrication shop shall have valid U2 code stamp as per ASME Sec. VIII Div. 2.
3. In case bidder on his own does not meet the criteria specified above, he can still be qualified provided:
i) Bidder must have designed, shop fabricated, assembled, hydro-tested in single piece at shop and supplied at least one reactor / column / vessels as per ASME Sec. VIII Div. 2 of not less than 1.0 meter diameter and 40 MT fabricated weight with material of construction as 2 ? Cr – 1 Mo + SS 347 Clad / Weld Overlay of thickness not less than 32 mm of equipment base metal thickness.
ii) The bidder engages a back up consultant who meets the requirements above.
iii) The design documents, fabrication drawings and Welding Procedure Specification (WPS) & Procedure Qualification Record (PQR) prepared by the bidder are approved / vetted by the back-up consultant.
iv) The bidder furnishes along with his bid the MOU / Letter of Agreement / Letter of Consent with the proposed back-up consultant confirming the scope of work as defined under clause (ii) & (iii) above.

未經允許，不得轉載本站任何文章：